Medtronic 500 T Operations Instructions download pdf (Page 17)

LIFEPAK 500T AED TRAINING SYSTEM Operating Instructions 9

Using the Remote Control

3. USING THE REMOTE CONTROL

This section describes the functions of the remote control and how the remote control interacts with

the AED Trainer. Refer to the following topics:

• Introduction, page 9

• Remote Control Cable, page 9

• Remote Control Functions, page 10

Introduction

During a training session, the instructor may use the remote control to create realistic training

scenarios. The remote control allows the instructor to:

• Vary the shock protocol at any time during the training session

• Pause AED Trainer operation

• Interrupt preconfigured routines with

NO SHOCK ADVISED, CONNECT ELECTRODES, MOTION,

SERVICE WARNING/REQUIRED, LOW/REPLACE BATTERY and CPSS prompts

• Select any one of the six available shock protocols (while in pause mode)

The remote control communicates with the AED Trainer via wireless infrared signals, or by means

of an optional cable. An indicator on the rear of the AED Trainer acknowledges received remote

control signals both with and without the cable:

• One red flash indicates valid signal reception from the remote control, and AED Trainer

operation responds accordingly.

• Three rapid red flashes indicate that an invalid remote control key was pressed, and AED

Trainer operation is unchanged.

• A steady red light indicates that the AED Trainer is in pause mode.

To use the remote control without the cable, the Trainer must stand behind the AED Trainer. During

use, hold the remote control level rather than aiming it directly at the AED Trainer.

Each time the AED Trainer is turned on, all remote selections from the previous training session are

deleted, with the exception of the current shock protocol which is stored in memory.

Remote Control Cable

To use the remote control cable, insert the cable’s right-angle connector into the remote control

connector located on the remote control. Insert the other end into the connector located on the side

of the AED Trainer (see Figure 1 on page 2).

Disconnect the remote control cable by grasping the connector at each end and pulling gently.

1 2 ... 12 13 14 15 16 17 18 19 20 21 22 ... 41 42

No comments

Medtronic 500 T Operations Instructions Page 17