Medtronic 500 T Operations Instructions download pdf (Page 11)

LIFEPAK 500T AED TRAINING SYSTEM Operating Instructions 3

Description

6 (Right arrow) Used in setup mode to move the cursor to the

right.

7 Icon lights red to simulate low battery power. Flashing red

icon indicates replace battery immediately.

8 Icon lights red to simulate service required by authorized

personnel.

9 Volume Control Three-level selection switch controls speaker volume.

10 Remote Control Signal

Receptor and Indicator

Remote control indicator lights to indicate signal reception

from remote control.

11 Training Electrode

Connector

Connection for the training electrodes.

12 Speaker Provides audio voice prompts and tones.

13 Remote Control

Connector

Connection for the remote control.

14 Battery Compartment Accommodates the removable battery pack.

15 Remote Control Storage

Compartment

Storage for remote control (in rear).

16 Readiness Display In an actual LIFEPAK 500 AED, the readiness display allows

the operator to determine if the AED is ready for use when the

device is turned off or when the key panel is not visible. The

readiness display is not functional on the AED Trainer.

Note: Not all LIFEPAK 500 AEDs have a Readiness Display.

Figure 2 Battery pack and training electrodes

17 Training Electrodes Use the AED Trainer training electrodes to practice accurate

electrode connection and placement.

18 Battery Pack Holds four standard D-cell batteries that provide power to the

AED Trainer. Installs into battery compartment.

Table 1 AED Trainer controls, indicators, and connectors (Continued)

Training Electrodes

Electrode Connector

Latch release

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 ... 41 42

No comments

Medtronic 500 T Operations Instructions Page 11